29
Error
Possible cause
Remedy
The meter cannot
Is the battery dead?
Check the battery status.
be switched on.
Remove the battery and insert it
again (reset device).
Measuring results are
Faulty measurement?
Check the flatness of the meter
faulty.
Is the sensor positioned flat
on the measured surface.
on the surface?
If necessary, use the provided
screw-on magnet.
If necessary, null balance the device.
Meter cannot be
The HOLD function is activated
Deactivate the hold function by
controlled.
(“H” is displayed)
pressing the "HOLD" button (3).
Undefined system status
Remove the battery and insert it
again (reset device).
Any repair work other than that described above must be carried out by an approved spe-
cialist.
If you have questions concerning the use of the meter, our technical support service is
available at the following telephone number:
Voltcraft, Lindenweg 15, 92242 Hirschau, tel. no. 0180 / 586 582 7
Specifications
Display..................................................LC display with bargraph
Sensor measuring frequency................10 Hz – 1 kHz (sensitivity according to ISO 2954)
Battery ..................................................1x 9V (PP3) battery (006P, MN1604)
Power input ..........................................approx. 13 mA
Operating temperature ........................0 to + 50°C
Relative humidity ..................................< 80%rF, non-condensing
Weight ..................................................Device approx. 253 g, sensor approx. 99 g
Dimensions (L x W x H mm) ................200 x 68 x 30 (device)
(
∅
x L mm) ..........................................16 x 37 (sensor)
Sensor cable length..............................approx. 1.2 m
Measuring tolerances
Accuracy at 80 and 160 Hz in ± (% of r display errors in counts (= number of smallest points)).
The accuracy is valid for one year at a temperature of +23°C (± 5°C) with relative humidity less than
80 %rF, non-condensing.
