background image

Wedgemaster II Ops Manual

 

3

 

 

 

Blades are sharp and can cause injury.  Check machine before using.  Be sure machine is clean.  Check for 
broken, nicked or dull blades and if found, replace blade assembly.  Check to be sure Pusher Head Assembly can 
move freely.  Lubricate if necessary using a light coating of mineral oil, Petrol Gel or food grade lubricant.  DO NOT 
LUBRICATE WITH COOKING OIL AS IT WILL BECOME STICKY. 
 

 
 

OPERATION INSTRUCTIONS 
 
 
 
 
 

1.  Place machine on a level counter or table. 
 
2.  When wedging lemons or limes, it is best to cut off both ends of the fruit. 

 

3.  When wedging tomatoes, use a Tomato King Scooper to remove the stem scar. 

 

4.  Raise the head of the Wedgemaster II with your right hand.  Center the product that you are going to cut on 

the center spike, which is the middle of the blade assembly. 

 

5.  Remove your hand away from the blade assembly.  With a strong, quick, downward thrust of the head 

assembly with your right hand, force the product through the blade to make perfect wedges. 

 

6.  Clean and lubricate your machine immediately. 

 
 

CLEANING INSTRUCTIONS

 

 

 
 
 
 

 
 
 
 
 
 
 
 
 
 

 

1.  Acidic foods can make the blades dull and corrode prematurely.  ALWAYS clean the Wedgemaster II after 

every use. 

 
2.  After use, remove the pusher assembly and base assembly and clean with warm, soapy water.  Rinse with 

hot water and let air dry.  DO NOT wipe the blades.  A brush and sprayer may be used to clean the blades. 

 

3.  The Wedgemaster II may be machine washed with mild detergents and with care to protect the blades. 

 
 

!

 

CAUTION: 

BLADES ARE SHARP AND CAN CAUSE INJURY.  NEVER USE MACHINE UNLESS 
ALL RUBBER FEET ARE IN PLACE. 

!

 

CAUTION: 

FOOD ACIDS WILL MAKE BLADES DULL AND CORRODE THE METAL.  
ALWAYS CLEAN THIS FOOD PREPARATION MACHINE IMMEDIATELY 
AFTER EVERY USE! 

!

 

DANGER: 

THIS MACHINE CONTAINS SHARP BLADES AND CAN CAUSE SERIOUS 
INJURY OR DEATH IF NOT HANDLED PROPERLY.  ALL OPERATORS OF 
THIS EQUIPMENT SHOULD READ THIS OPERATION MANUAL BEFORE 
OPERATING EQUIPMENT. 

!

 

CAUTION: 

PRIOR TO USING YOUR NEW EQUIPMENT, IT IS IMPORTANT TO CLEAN 
THE UNIT.  WASH NEW BLADES WITH WARM SOAPY WATER AND RINSE 
THOROUGHLY TO REMOVE THIN PROTECTIVE OIL FILM.  LET AIR DRY. 

!

CAUTION 

!

Summary of Contents for REDCO WEDGEMASTER II









Reviews: