The chassis dimensions can be taken from the following drawings (see p. 20-23). Chassis drawings,
on a scale of 1:20
and 1:10
, are available to help you planning the attachment.
If reinforced springs, enhanced springs are installed or if tyre sizes are used that are differing from the standard model,
vehicle and frame heights (as measured from ground level) may change considerably. In this case, it is necessary to
consider this equipment during projecting.
Important note
The minimum distance between cab and attachment must be at least 30 mm.
•
The rear overhang of the attachments must not exceed 40% of the wheel base.
•
The
maximum permitted overhang
(rear) of
40%
of the wheel base, results in the following max. external attachment
lengths for chassis. These values must not be exceeded:
Wheelbase
Standard attachment
length, interior
max. external attachment
length, 40% overhang
Chassis with
driver™s cab
2.920 mm 2.505 mm
2.686 mm
Chassis with
driver™s cab
3.320 mm 2.905 mm
3.246 mm
Chassis with
double cab
3.320 mm 2.140 mm
2.476 mm
Attachment width:
The exterior width of the driver™s cab is 1,840 mm. If the standard exterior mirrors are used, the attachment width must
not exceed 2,200 mm.
Note:
Subject to errors and technical amendments. The electronic version of the body guidelines is the decisive source of up-to-date data on body guidelines (online body
guidelines). Data status August 2007
16
