Fig. 181
License plate light: Removing the bulb holder.
¤
Please first read and note the introductory information and heed the WARNINGS
Please carry out each step only in the order specified:
1.
Please review and follow the checklist
2.
Carefully insert the flat blade of the screwdriver from the vehicle tool kit in the direction of
the arrow into the slot in the license plate light trim
⇒
fig. 154
.
3.
Pull the license plate lamp out slightly.
4.
Press the locking mechanism on the connector in the direction of the arrow
⇒
fig. 181
(A)
and pull the connector plug off.
5.
Turn the bulb socket in the direction of the arrow
(B)
.
6.
Pull the burned out light bulb out in the direction of the arrow and replace with a new bulb of
the same type.
7.
Insert the bulb socket in the license plate light and turn it opposite the direction of the arrow
(B)
until it stops.
8.
Connect the connector to the bulb holder.
9.
Insert the license plate light carefully into the opening in the bumper. Make sure the license
plate light is installed in the correct direction.
10.
Press the license plate light into the bumper until you hear it click into place.
Different models may have different lights, and the location and design of covers, bulb holders,
and bulbs may be in a different location than shown in the illustrations.
You cannot replace the LEDs in LED license plate lights. Contact your authorized Volkswagen
dealer or an authorized Volkswagen Service Facility for assistance.
