¤
Please first read and note the introductory information and heed the WARNINGS
Instrument explanations
⇒
fig. 12
:
(1)
Engine oil temperature indicator
The engine has reached operating temperature when the needle moves into the center of the
gauge under normal driving conditions. The needle may move farther to the right on the gauge
with a heavier engine load at high outside temperatures. This is not a cause for concern as long
as the indicator light
E
or
does not light up or flash in the instrument cluster,
Warning and
indicator lights
,
Warning and indicator lights
.
(2)
Stopwatch
– Analog stopwatch that measures up to 60 seconds.
– Digital stopwatch with hour, minute and second display (one tenth of a second intervals are
shown up to 59 minutes and 59 seconds when the ignition is switched on).
– Digital display with stop function selected.
– Digital clock display with hours and minutes. If the timing function is not active, the digital
clock will display after the ignition is switched on.
(3)
Boost pressure indicator
The boost pressure indicator shows the pressure in the boost pressure duct between the su-
percharger or turbocharger and the engine. The farther right that the indicator points on the
gauge, the higher the pressure in the boost pressure duct and the greater the output from the
engine. The word “Turbo” on the gauge indicates the system is charged.
(4)
Start / Stop / Reset button
– Stopwatch mode (
STOP-WATCH
): press the button
E
3%4
once to start timing and press a se-
cond time to stop. Press the button
E
3%4
again to resume timing.
– Speed-dependent stopwatch mode (
TIME-SINCE-START
): the stopwatch starts automati-
cally with an audible chime when you begin driving. Press once to stop the watch.
– Press and hold longer than 2 seconds: the stopwatch resets.
– When the digital clock (
CLOCK
) is displayed, you can switch between a 12-hour and 24-hour
display by pressing the
E
3%4
button.
(5)
Button for stopwatch mode or digital clock
You can switch between stopwatch modes and the digital clock display using the set button
.
After selecting the stopwatch in the display, the mode displays briefly, followed by the last time
that a time was recorded.
– Stopwatch mode (
STOP-WATCH
).
– Speed-dependent stopwatch mode (
TIME-SINCE-START
). The stopwatch starts automati-
cally with an audible chime when you begin driving. An LED in the stopwatch comes on to
indicate that this mode is active
⇒
.
– Digital clock display (
CLOCK
).
If the ignition is switched off while the timing function is active, the display will remain active for about
2 hours. If the timing function was not active when the ignition was switched off, the digital clock dis-
play will turn off after about 30 seconds.
The display will remain on for about 2 hours if you press the
E
3%4
or
button within about 30 seconds
after switching the ignition off.
WARNING
Rapid acceleration can cause skidding and loss of traction, especially on slippery roads,
resulting in a loss of vehicle control, collisions, and serious personal injury.
x
Only use the stopwatch feature or fast acceleration if visibility, weather, road, and traffic
conditions permit and other drivers will not be endangered by your driving and the vehicle's
acceleration.
