Vogtlin SmartTrak 100 Series, Manual

Page: 44 / 114

44
Change Output
Signals
X-XX XX/X-XX XX
You can make additional changes by using the left and right arrow keys to move to other
Lower Level Screens. You may also choose to press the escape key to return to the Upper
Level Screens.
Change Full Scale Screen
If you are already in the Lower Level Screens, push the right or left arrow until you reach
the Change Full Scale screen. To get to this screen at any time: Press Escape—Press
Enter—enter password and Press Enter. Then, press the Right or Left arrow until you
reach this screen
.
The display will show:
Change Full Scale
XX.XX sl/m
Air
This screen allows you to re-range the outputs of your instrument. You may select any
full-scale value between 100% and 50% of the displayed maximum value (this is the
factory full-scale calibration value).
The new full-scale value that you select will re-define the analog outputs of the
instrument. The 20 mA signal and the corresponding voltage signal (5 VDC, 1-5 VDC or
10 VDC) will now represent this new full-scale value.
Caution: Changing the full-scale value of the instrument does not affect the
accuracy.
The accuracy is always

1% of full scale under calibration conditions of the original
factory full-scale calibration value.
Caution: For any instrument, if a value greater than the factory full scale calibration
value is entered on this screen, the SmartTrak will modify the requested value to
equal the factory full scale calibration value.
If you choose to change the full-scale value, press the enter key. The first digit will blink.
Use the up and down arrows to adjust the value of the digit or the left and right arrows to
choose another digit. When you have completed your modification, press the enter key.
The display will show:
Change Full Scale
XX.XX sl/m