Vogtlin SmartTrak 100 Series, Manual

Page: 41 / 114

41
If you wish to change the gas used in the instrument, press enter. The name of the gas will
blink. Use the up and down arrows to make your selection. When you reach the desired
gas, press enter. You will see:
Change Gas
XXXX
You can make additional changes by using the left and right arrow keys to move to other
Lower Level Screens. You may also choose to press the escape key to return to the Upper
Level Screens and to observe your change.
Caution!
The SmartTrak
valve is not a positive
shut-off device.
Note: your instrument comes with 10 pre-programmed standard gases. These are listed in
the Specifications in Appendix B
. SmartTrak may be ordered with alternate gases
programmed. If your device was so ordered, you may choose from these 10 gases instead.
You may see the 10 gases programmed in your instrument by using this screen and simply
scrolling up or down.
Change Valve Operation-Close, Purge
If you are already in the Lower Level Screens, push the right or left arrow until you reach
the Change Valve Operation screen. To get to this screen at any time: Press Escape—
Press Enter—enter password and Press Enter. Then, press the Right or Left arrow until
you reach this screen. The display will show:
Change Valve
Operation
Automatic
From this screen you may set the valve to open all the way (“Purge”), force the valve to
remain closed until further changes are made (“Valve Closed”) or set the valve to control
flow when it receives a setpoint from some source (“Automatic”). To make a change to
the valve operation, press the enter key. Use the up and down arrows to make your
selection. When you are satisfied, press the enter key again. You will see:
Change Valve
Operation
XXXXX
You can make additional changes by using the left and right arrow keys to move to other
Lower Level Screens. You may also choose to press the escape key to return to the Upper
Level Screens.