Maintaining Your Badge ··· 119
Maintaining Your Badge
The Vocera badge requires very little maintenance: just recharge the battery
when the power gets low, and clean the badge when necessary. The following
sections describe how to charge the battery and how to clean the badge.
When to Charge the Battery
You must charge a new battery before you can use it. After that, you must
recharge the battery as needed for the badge to operate properly.
There are several easy ways to check whether you need to recharge the battery:
1. The green indicator light on the top of the badge turns red and blinks
rapidly.
2. The battery-level indicator on the badge display shows empty.
Figure 32. Battery-level indicator
3. An alert signal plays at regular intervals.
Note:
This signal may be disabled by the system administrator on request.
Preparing the Charger
Important:
Before you use a charger, read
Important Safety Instructions
on
page 153.
To prepare the charger for use, insert the single-pronged plug into the outlet in
the charger, and plug the two-pronged power plug into a 110 VAC outlet.
Summary of Contents for B2000
