S
ecti
on 5
- Cof
fee
&
P
ow
der
S
ys
tems
Service Manual
VKI Publication #100309-001
42
Installing the whipper system components
1.
Connect the inline wiring connector that supplies power to the whipper motor.
2.
Install the new motor into the cutout in the machine wall. Install the bottom of the
assembly first, and then push the top of the assembly into the cutout until the plastic
clip locks it in place.
3.
Secure the mount to the wall with a screw, and then install the base onto the mount.
NOTE: When re-installing the screw, the torque must be 15 in/lbs.
4.
Install the impeller onto the shaft (line up the arrow on the impeller with the flat side
of the shaft).
