S
ecti
on 4
- Bre
w
er
S
yst
em
Service Manual
VKI Publication #100309-001
26
5.
Assemble the new cylinder
(consult VKI Publication #100310-001 for the required parts
and their part numbers).
A)
Install the valve housing onto the cylinder (making certain in is pushed down
completely), and then install the two o-rings onto the valve housing.
B)
Install the U-cup seal into the valve housing.
C)
Install the thick o-ring onto the valve head.
D)
Pass the valve head through the valve housing from the inside of the cylinder. You
need to hold the valve head in this position to perform the next step.
E)
Place the spring into the U-Cup seal (with the valve head in the middle of the spring)
and then install the valve activator over the spring (flatter side towards the front).
While holding the valve body in place inside the cylinder, press firmly on the valve
activator until the tip of the valve body passes through the activator, locking
everything in place.
F)
Install the large o-ring into the recession in the bottom center of the cylinder.
