VHT Raptor Manual Ver. 3.1
36
05
th
June 2012
■
SCAN NO
A maximum of 5 Scans can be registered.
■ SCAN NO DEF
OFF
SCAN is cancelled
ON
SCAN can be set up (it should be “ON” for operation in AUTO RUN)
<Setting example>
SCAN NO
1
2
3
4
5
SCAN DEF
ON OFF ON OFF ON
SCAN will be executed in programmed preset 1,3 &5.
The method for setting up SCAN1 in PRESET is as follows:
1. Register “1” as the SCAN NO.
2. Change SCAN DEFINE from OFF to <ON> and press the IRIS OPEN KEY.
■ NAME
This changes the SCAN Name.
The method for changing the SCAN NAME is as follows:
1. Change SCAN NAME DEF from OFF to <ON> and press the IRIS OPEN KEY.
2. The method
for changing the SCAN name is the same as for “1.3 CAMERA NAME
DISPLAY”.
■ PAN START POS
This sets up the initial location for the SCAN.
The method for setting up a SCAN is as follows:
1. Press the IRIS OPEN KEY in PAN START POS.
PAN START POSITION SET
PAN START POSITION: XXX
EXIT: IRIS CLOSE
PAN Shift:
LEFT, RIGHT KEY
2. After moving to the desired position, press the IRIS OPEN KEY.
■ PAN END POS
This sets up the finish location for the SCAN.
The method for setting up PAN END POS is the
same as for “PAN START POS”.
■ TILT POS
This sets up the TILT angle in the SCAN.
Set up is similar to “PAN START POS” but the UP, DOWN KEY should be used.
■ SCAN SPEED
Sets up the SCAN Speed.
