APPLICATION
In the AP mount the electrical circuit board is protected by a fuse. It is a rare case that a
fuse is cut off in general use of the mount. If this happens, you will need to replace the fuse
with a fresh one.
Remove the declination body cover.
Open up the polar scope window on the declination body by sliding down the shutter. While pushing down on the hook on the
bottom of the declination body, pull out the declination body cover by pinching the hook and window hole with fingers.
Remove the cover of the fuse box.
Remove the batteries from the declination body. Do not disassemble the mount without removing the batteries. This may cause
damage.
About a Fuse Box
pecifications:
125V 1A Class-B
(PSE standard)
6mm dia. x 30mm
Replacing the Fuse
1
2
3
Pull out fuse.
4
P u s h a n ew f u se i nto t h e f u se b ox to set .
5
Put the cover on the fuse box and install the batteries, if
necessary.
6
Replace the declination body cover noting the direction of
the hook on the cover.
7
Polar scope window
Polar scope window
Declination body cover
Declination body cover
Hook
Hook
Fuse
Fuse
Fuse box cover
Fuse box cover
Fuse
Fuse
Fuse box cover
Fuse box cover
Declination body cover
Declination body cover
27
