4x2 HDMI 2.0 Seamless Matrix Switcher
10
3.3 Receiver Front and Rear Panel
①
Power LED:
The LED illuminates red when power is applied.
②
ARC Mode:
Press the button with paper clip or other sharp tool to enable the
ARC mode, and then the left LED illuminates blue. Press it again to exit the ARC
mode and the LED is off. The ARC mode also be enabled/disabled by sending
RS232 command.
③
ARC Audio In:
Toslink connector to connect ARC audio source device (e.g.TV).
④
FW:
Micro-USB port for firmware upgrade.
⑤
HDMI Out:
Type-A female HDMI output port to connect HDMI display (e.g.TV).
⑥
Audio Breakout:
If the ARC mode is OFF, the Toslink connector is connected to
speaker or amplifier for HDMI source audio de-embedding. Note that if the ARC
mode is ON, this port has no audio output.
⑦
IR In:
3.5mm jack to connect the IR receiver for IR pass-through.
⑧
IR Out:
3.5mm jack to connect the IR emitter for IR pass-through.
⑨
RS232:
3-pin terminal block to connect the RS232 control device (e.g. PC) or a
third-party device to be controlled.
⑩
HDBT In:
RJ45 port to connect the HDBT output port of switcher/transmitter by
CATx Ethernet cable. The LINK LED illuminates orange when there is a valid
HDBaseT link between the switcher/transmitter and the receiver. The HDCP LED
illuminates green when the video contains HDCP content.
⑪
DC 24V:
DC connector for the power adapter connection. If the
switcher/transmitter is connected to the power adaptor, the receiver doesn’t need
to connect power adaptor due to the HDBT output port of switcher/transmitter
supports 24V PoC output.
1
2
3
4
5
6
7
8
9
11
10