16
Operation
Installing the USB wireless dongle
Follow the illustrations below to install the USB wireless dongle. Make sure that the
cover is installed back after the USB wireless dongle is plugged. Do not turn the power
on with the cover open.
Powering On the Projector
1. Complete the AC power cord and peripheral signal cable(s) connections.
2. Press
on the projector or
ON
on the
remote control to turn on the projector.
The projector takes a minute or so to warm up.
3. Turn on your source (computer, notebook,
DVD, etc.). The projector automatically detects
your source when Auto source setting is ON.
• If the projector doesn't detect a valid signal,
the message 'No Signal' will continue to be
displayed.
Warning
•
Never look into the lens when the lamp is on. This can damage your eyes.
•
This focal point concentrates high temperature. Do not place any object near it to avoid
possible fire hazard.
Powering Off the Projector
1. Press
on the projector or
OFF
on the remote control to turn off the projector
lamp. You will see a message "Power off Please press power again" appear on
the screen.
2. Press
on the projector or
OFF
on the remote control again to confirm.
• If you want to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered stand-by mode. Once in stand-by
mode, simply press
on the projector or
ON
on the remote control to
restart the projector.
3. Disconnect the AC power cord from the electrical outlet and the projector.
4. Do not turn on the projector right after power off.
1
2
3
