DU6771 DLP Projector User Manual
44
UN67711216EN00
Rear:
Turn on rear IR receiver only; front IR receiver is turned off.
HDBaseT:
Select HDBaseT input for IR control signal transmitting if the optional HDBaseT transmitter is capable of
IR signal receiving and transmitting. Both front IR receiver and back IR receiver are turned off if the option is
selected.
Off:
Turn off all of receivers.
All of IR signal receiving is disabled when the option is selected to Off, the projector can be operated
by control buttons on the projector and RS-232 command only.
Network
Use this function to set up network configurations so that you can control the projector via the network. Press
▲
or and
Enter button to select the option:
IP Address:
To specify an IP address.
Press the Enter button to show the IP address input window, use the
◄ or ► button to select the number in the
address to be changed,
▲
or
▼
button to increase or decrease the number in the IP address.
Subnet:
Set the subnet, the input method is same as the IP address.
Gateway:
Set the gateway, the input method is same as the IP address.
DNS:
Set the DNS, the input method is same as the IP address
DHCP:
Set DHCP to ON/OFF. When DHCP is set to ON, the DHCP server of the domain will assign an IP address
to the projector. The IP address will appear in the IP address window and you don't need to make any input.
Otherwise, the domain does not or cannot assign any IP address, and 0. 0. 0. 0 is shown on the IP address window.
Apply:
Select this button and press Enter. It takes the projector several seconds to execute the change of the
network setting till the following message disappears.
MAC Address:
Display Mac address of the projector.
For more information about the network control connection and setting, refer to Remote Communication Guide
Any change you made is restored in the projector after Apply option is confirmed.