DU6771 DLP Projector User Manual
47
UN67711216EN00
Corner Adjustment
Keystone adjust the four corners followed specified ratio at the same time, this function allows you to adjust the
individual corner in horizontal or vertical direction as below illustration
Refer to Correcting Distortion at the Corner on page 22.
Advance
RS232
Baud Rate:
Set the transmission rate to 38400, 19200, 9600. The setting of the transmission rate is dependent on
the length of the RS-232 cable. Low transmission rate is usually set for which transmission distance is long; please
select a suitable transmission rate.
Channel:
The RS232 control command can be sent to the projector through its RS-232 port, the command can also
be sent to the projector through the external HDBaseT transmitter to HDBaseT/LAN terminal of the projector. Set
the following communication channels before sending the control command
Local:
The RS-232 control command is sent through the RS-232 port on the projector. Select an appropriate
transmission rate.
HDBaseT:
Transmission is conducted from the external HDBaseT transmitter to the RJ-45 port on the projector.
The transmission rate is switched to 9600.
Auto Power Off
This function is set to OFF by default. When it is set to ON and no input signal is received within 20 minutes, the
projector will turn off automatically.
Auto Power On
This function is set to OFF by default. When it is set to ON, the projector will turn on automatically when y AC power is
turned on next time. You can use this function and the power switch (instead of the remote control) to turn on the
projector. Set this function to OFF if it’s unnecessary.
Message Box
This function allows you to disable the pop-up message at bottom-right of the screen or any reminding message.
Set this option off to disable the message on the screen except of OSD menu.
