– 28 –
D
D
D
L
L
L
P
P
P
P
P
P
r
r
r
o
o
o
j
j
j
e
e
e
c
c
c
t
t
t
o
o
o
r
r
r
—
—
—
U
U
U
s
s
s
e
e
e
r
r
r
’
’
’
s
s
s
M
M
M
a
a
a
n
n
n
u
u
u
a
a
a
l
l
l
I
TEM
D
ESCRIPTION
D
EFAULT
Motorized
zoom
Press the cursor
button to adjust the motorized zoom.
—
H keystone
Press the cursor
button to correct horizontal distortion of the projected
image. (Range: -100 – +100)
0
V keystone
Press the cursor
button to correct vertical distortion of the projected
image. (Range: -100 – +100)
0
Lamp control—Press the cursor
button to display the hidden Lamp control submenu.
Mode
Press the cursor
button to toggle between Dual lamp and Single lamp.
Dual lamp uses both lamps in the projector. Single lamp uses the lamp
which has been used the least.
Dual lamp
Lamp 1
Press the cursor
button to toggle between ECO mode and Normal
mode. Eco mode uses less power and extends lamp life, but decreases lamp
brightness.
Normal
Lamp 2
Press the cursor
button to toggle between ECO mode and Normal
mode. Eco mode uses less power and extends lamp life, but decreases lamp
brightness.
Normal
OSD settings—Press the cursor
button to display the hidden OSD settings submenu.
Position
Press the cursor
button to position the OSD on screen.
(Range: Left – Right – Center – Down – Up)
Center
Transparency
Press the cursor
button to set menu screen translucency.
(Range: 0 – 100)
50
Timeout(sec)
Press the cursor
button to determine the timeout delay of the OSD.
(Range: Always on – 100 seconds)
20
Message
Press the cursor
button to show or hide the OSD information screen in
the bottom-right corner of the screen.
On
Menu type
Press the cursor
button to toggle between Expert mode and Normal
mode. In Expert mode all settings are available in the OSD.
Expert
Logo settings—Press the cursor
button to display the hidden Logo settings submenu.
Logo display
Press
to enable or disable if the logo displays when the projector
starts, and when no source is detected. (Range: On—Off)
On
Logo select
Press
to select a different image for the logo display. To use this func-
tion you must capture an image with the following “Logo capture”
function.
Default
(preset
image)
