Vivax ACP-12CT35GEEI, User Manual

Page: 141 / 152

Installation of indoor unit
INSTALATION INSTRUCTIONS
The mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark
the boring points on the wall.
2) Secure the mounting plate to the wall with screws
Floor installation Wall installation
3) Once refrigerant piping and drain piping connections are complete, fill in the gap of the through hole
with putty. A gap can lead to condensation on the refrigerant pipe, and drain pipe, and the entry of
insects into the pipes.
4) Attach the front panel and front grille in their original positions once all connections are complete.
Flaring the pipe end
1)Cut the pipe end with a pipe cutter.
2)Remove burrs with the cut surface facing downward so that the chips do not enter the pipe.
3)Fit the flare nut on the pipe.
4)Flare the pipe.
5)Check that the flaring is properly made
WARNING
1. DO not use mineral oil on flared part.
2. Prevent mineral oil from getting into the system as this would reduce the lifetime of the units.
3. Never use piping which had been used for previous installations. Only use parts which are delivered with
the unit.
4. Do never install a drier to this R410A unit in order to guarantee its lifetime.
5. The drying material may dissolve and damage the system.
6. Incomplete flaring may cause refrigerant gas leakage
Casing
6 screws
Molding