Vivax ACP-12CT35GEEI, User Manual

Page: 129 / 152

button changes the time setting by 1minute. Holding down either button rapidly changes the
time setting by 1 minute and then 10 minutes.Within 5 Seconds after setting,press TIMER ON
button to confirm.
Press T-OFF button to initiate the auto-off timer. To cancel the auto-timer program, simply
press the button again.TIMER OFF setting is the same as TIMER ON.
14 TURBO
Press this button to activate / deactivate the Turbo function which enables the unit to reach
the preset temperature in the shortest time. In COOL mode, the unit will blow strong cooling
air at super high fan speed. In HEAT mode, the unit will blow strong heating air at super high
fan speed
15 LIGHT
Press LIGHT button to turn on the display's light and press this button again to turn off the
display 's light. If the light is turned on
is displayed. If the light is turned off, disappears.
16 X-FAN
Pressing X-FAN button in COOL or DRY mode,the icon is displayed and the indoor fan will
continue operation for 10 minutes in order to dry the indoor unit even though you have turned
off the unit. After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO,FAN
or HEAT mode
17
Combination of "+" and "-" buttons: About lock
Press " + " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller
is locked,
is displayed. In this case, pressing any button, blinks three times.
18
Combination of "MODE" and "-" buttons: About switch between Fahrenheit and centigrade At
unit OFF, press "MODE"and"-" buttons simultaneously to switch between
°C
and
°F
19 Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function
20
Combination of " TEMP " and "CLOCK" buttons : About 8'C Heating Function
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start 8C Heating Function
Nixie tube on the remote controller displays and a selected temperature of " 8 C " .
(46
° F if Fahrenheit is adopted). Repeat the operation to quit the function.
21
About Back-lighting Function
The unit lights for 4s when energizing for the first time, and 3s for later press
• Replacement of Batteries
1. .Remove the battery cover plate from the rear of the remote
controller.(As shown in the figure)
2. Take out the old batteries.
3. Insert two new AAA1.5V dry batteries, and pay attention to the
polarity.
4. Reinstall the battery cover plate.
Notes:
•
When replacing the batteries, do not use old or different
types of batteries, otherwise, it may cause malfunction.
•
If the remote controller will not be used for a long time,
please remove batteries to prevent batteries from leaking.
•
The operation should be performed in its receiving range.
•
It should be kept 1 m away from the TV set or stereo sound
sets.
•
If the remote controller does not operate normally, please
take the batteries out and reinsert them after 30 seconds.If
it still can't operate properly, replace the batteries.
Sketch map for replacing batteries