Vitrek Xitron 2801, User Manual

Page: 79 / 182

Using the Power Analyzer 79
SETUP SYSTEM MENU
CONTRAST 5
BACKLIGHT ON
DIGITAL I/O
IEEE-488 ADDRESS 2
RS-232 BAUD RATE 115200
SET DATE 8/1/06
SET TIME 09:01:36AM
DATE FORMAT MM/DD/YY
TIME FORMAT 12 HOUR AM/PM
LANGUAGE ENGLISH
Using the Line Switch and Inrush Capabilities
The following terms describe available settings for the Line Switch (Channel
1 only) and commands that can be initiated. All settings and commands can
be made from the front panel interface or by way of a control interface. Most
settings take affect on the next communication with the device-under-test.
Line On
A command initiated by pressing the front panel LINE ON/OFF key when the
LED is extinguished, or by means of a command issued via a control
interface. Note that this is not necessarily the state of the internal line switch.
Line Off
A command initiated by pressing the front panel LINE ON/OFF key when the
LED is illuminated, or by means of a command issued via a control interface.
Note that this is not necessarily the state of the internal line switch.
Rearm
A command initiated by pressing one of the front panel, F1 through F4 keys,
available when the LINE ON/OFF LED is illuminated, or by means of a
command issued via a control interface
Using the Line Switch
Make a signal connection to the device-under-test by pressing the front panel
LINE ON/OFF key with the internal line switch set to ENABLE. Its lighted
LED indicates connection.
CAUTION: When the line switch is set to DISABLED, it is actually held in
the ON (shorted) state. Do not connect the A+ and LINE terminals to different