Vitrek Xitron 2801, User Manual

Page: 112 / 182

112 2801/2802 Power Analyzer User Guide
RECALL=value – recalls and executes the configuration from store # set by
value
ERASE=value – erases any configuration stored in the store # set by value
IEEE488 Status Byte Commands
The IEEE488 interface has an SRQ capability which is controlled by a status
byte internal to the 2801/2.
The STATUS, *SRE and *STB commands are provided with the standard
IEEE488.2 syntax to control the use of the IEEE488 status byte.
Commands which affect the measurement process
MEASUREMENT? – this interrogative queries the state of the RUN/HOLD
front panel control. 0 is returned if the 2801/2 is presently in HOLD, 1 is
retuned if it is presently in RUN.
MEASUREMENT(CH2)? – this interrogative queries the state of the
RUN/HOLD front panel control. 0 is returned if the 2801/2 is presently in
HOLD, 1 is retuned if it is presently in RUN. This is for the state of channel
2 integration when the 2802 is configured for 2ch (Async) applications.
MEASUREMENT=0 – disables measurements. Disables both channels (i.e.
all measurements) if not configured for 2ch (Async) applications, otherwise
disables only channel 1.
MEASUREMENT(CH2)=0 – disables measurements on channel 2 only (only
when configured for 2ch (Async) applications).
MEASUREMENT=1 – enables measurements. Enables both channels (i.e. all
measurements) if not configured for 2ch (Async) applications, otherwise
enables only channel 1.
MEASUREMENT(CH2)=1 – enables measurements on channel 2 only (only
when configured for 2ch (Async) applications).
CLR-WAVECAPTURE – this command resets and clears the waveform
capture system
WAVECAPTURE=0 – disables waveform capture