16
CO2 set
| Instruction
manual
rev-03_May 2022
4
.
Installation
This chapter provides instructions for the basic installation of a CO
2
set onto a boiler or other heating appliance. For
information about a custom set-up, please contact Vitotherm.
6
CAUTION!
The CO
2
set may only be installed by qualified personnel. Handling the CO
2
set and supporting
components without the required knowledge and experience may damage the CO
2
set or cause
hazardous situations during installation and use.
6
WARNING!
The CO
2
set may only be installed in a sufficiently ventilated boiler house.
NOTICE
The CO
2
set must always be installed according to national and local laws and regulations.
4.1
.
Checking the delivery
Required tools:
•
Forklift truck with adequate lifting capacity.
To check the delivery:
1. Transport the crate(s) to an accessible place near the boiler.
2. When delivered in an optional transport crate:
a. Remove the lid of the crate(s).
b. Remove the sides of the crate(s).
c. Remove the lashing straps and packaging materials.
d. Remove any screws that connect parts to the bottom of the crate(s).
3. Check if all parts have been delivered according to the agreed scope. If a part is missing, contact Vitotherm immediately.
4. Check all delivered parts for damage.
6
WARNING!
Damaged parts can affect the correct and safe functioning of the CO
2
set.
f
Do not install damaged parts.
f
If any parts are damaged upon delivery, please contact Vitotherm.
5. Check if the delivered CO
2
set will fit in the designated area of the room. For the dimensions of the CO
2
set, see §
3.8
.
.
4.2
.
Preparing the elevation structure
The CO
2
dosing unit can be installed on a supporting elevation structure. The mounting frame of the dosing unit can be
expanded with legs to create this elevation structure.
The CO
2
dosing unit can also be installed on the floor. In this scenario, support feet can be attached to the mounting frame.
NOTICE
The elevation structure or support feet are not part of the standard delivery and may have to be
created as part of the installation process.
