LIMITED LIABILITY WARRANTY
VITEK products carry a three (3) year limited warranty. VITEK
warrants to the purchaser that products manufactured by VITEK
are free of any rightful claim of infringement or the like, and when
used in the manner intended, will be free of defects in materials and
workmanship for a period of three (3) years, or as otherwise stated
above, from the date of purchase by the end user. This warranty is
nontransferable and extends only to the original buyer or end user
customer of a VITEK Authorized Reseller.
The product must have been used only for its intended purpose, and
not been subjected to damage by misuse, willful or accidental damage,
caused by excessive voltage or lightning.
The product must not have been tampered with in any way or the
guarantee will be considered null and void.
This guarantee does not affect your statutory rights.
Contact your local VITEK Reseller should servicing become
necessary.
VITEK makes no warranty or guarantee whatsoever with respect to
products sold or purchased through unauthorized sales channels.
Warranty support is available only if product is purchased through a
VITEK Authorized Reseller.
Version 1.1
Sept 2014
28492 ConsTEllATIon RoAd
VAlEnCIA, CA 91355
WWW.VITEKCCTV.CoM
Installation Instructions
Installation Instructions
5
7
8
6
Without using an Easy Bracket
1. locate the mounting template at the installation position and drill the ceiling
or wall if needed.
2. Insert the Anchors to the drilled holes.
3. Route the power cable to the connecting place.
4. Affix the camera bracket using the assembly screws (4x14mm).
5. set the camera’s viewing angle.
6. Put the sunshield to the camera unit and tighten the sunshield-bolt.
With using an Easy Bracket
1. locate the mounting template at the installation position and drill the ceiling
or wall if needed. (*The easy bracket can not be installed on the ceiling)
2. Place the easy bracket on pre-drilled position and attach using mounting
screws(4x30mm). skip this step when an easy bracket is not installed.
3. Route the power cable to the connecting place.
Hook up the camera bracket with the easy bracket.
4. Affix the camera bracket using the assembly screws (4x14mm).
5. set the camera’s viewing angle.
6. Put the sunshield to the camera unit and tighten the sunshield-bolt.
Mounting the camera on wall
WINDOW
SUNSHIELD BOLT
SUNSHIELD
OSD Setup
CONTROL COVER
BRACKET
CAUTION
• Extreme care should be taken NOT to scratch the window in front of
lens while installing or adjusting the camera.
• Care should be taken the cable is NOT damaged, kinked or exposed in
a hazardous area.
• Do not expose the camera lens directly to a strong light source such as
the sun or a spot light.
IR LED
Installation Instructions
Power Supply Connections
• Make sure the power is removed before installation.
• After all connections are finished properly, follow the order for applying
power.
a) Plug the network cable into RJ-45 Ethernet Port at the rear panel.
If PoE is the unique power, there will be no need to connect Power terminal.
b) When dC12V or AC24V local power is necessary, first connect the low voltage
(dC12V or AC24V), then plug the AC adapter to AC outlets to avoid an improper
reset from power spike and damage from a voltage surge with no load.
When PoE and local power are connected, local power has priority
Camera can work with either 24VAC or 12VdC, dual voltage power and PoE (IEEE
std. 802.3af). Primary and secondary grounds are completely isolated to avoid the
possible ground-loop problems.
50mm
50mm
※
Parts Name
