ENVI Series IP Configuration Manual
________________________________________________________________________________
9
3. System Operation
1. Remote Video Monitoring
There are two ways to monitor video when the decoder site and the ENVI IP2 Camera are connected.
For proper operation, an IP address must be set accordingly. Please refer to
ENVI VMS in Chapter 3
or
Remote Setting in Chapter 4
for further details.
Default ID: admin
Default Password: 1234
Video Monitoring with Decoder System
Once the ENVI IP2 Camera‟s IP address is set in the remote IP address section of the decoder, the
decoder system will connect to the ENVI IP2 Camera and start receiving the video images. Normally, a
monitor connected to the decoder will display video images.
Video Monitoring using Internet Explorer
Open Internet Explorer and enter
your ENVI IP2 Camera‟s IP address. The system will ask for
confirmation to install Active-X control. Once authorized, Internet Explorer will start to display video
images from the ENVI IP2 Camera as shown below.
Default IP Address: http://192.168.10.100
Summary of Contents for VTC-C770/WDR
Page 44: ......
Page 45: ......
Page 46: ......
Page 48: ...28492 CONSTELLATION ROAD VALENCIA CA 91355 WWW VITEKCCTV COM 888 VITEK 70...