Vitek VTC-C2BTS2, Manual

Page: 8 / 28

Installation Instructions
Installation Instructions
• Care should be taken that the cable is NOT damaged, kinked or exposed in
a hazardous area.
• Do not point the camera lens directly at the sun or a spot light.
• The camera has a 1/4” thread insert on top and bottom for mounting
the camera to a wall or ceiling with a corresponding mount.
Power Supply Connection
Camera can work with either 24VAC or 12VDC, dual voltage power.
Primary and secondary grounds are completely isolated to avoid the possible
ground-loop problems.
Using OSD Controller
Setup menu can be accessed and controlled by OSD control joy stick on the rear
of the camera unit. Five commands are available with the joy stick. The design
of OSD could be different according to the Model.
Description of the joystick operation
1) SET Key (●) : Access to the menu or enter the setting.
To enter the main menu, press the Set Key down for about 1.5sec
2) UP/DOWN Key (▲/▼) : Choose the desired sub-menu and to move
the cursor up or down.
3) LEFT/RIGHT Key (◄/►) : Set up the value of the selected menu.
Used to adjust the desired menu selection and to move the cursor left or right.
4) denotes a long press down for about 2 seconds
Description of the D-ZOOM* adjustment
1) ▲ : Zoom In 2) ▼ : Zoom Out
(*) Works only when OSD Menu is inactive.
Do not power off the camera immediately after switching the video format .
It can cause a crash of the flash memory.
Description of Video format switch (TVI
↔
CVBS)
1) Selects the video output TVI or CVBS. Default position is TVI.
2) Switching the video format : ▲,▼, ▲,▼,
●
( long push 1~2 sec.)
8 9