5
5. Installation Instructions
•
Make sure the power is not applied before the installation.
•
Once the camera is installed, you may first connect the low voltage (AC24V or DC12V) wire to the
camera power connector, then plug the AC adapter to the AC outlets to avoid an improper reset from
power jitter and possible damage from voltage surge.
5.1 Mounting the Camera
1) Drill 3 holes into the wall or ceiling using the supplied template
2) Insert the supplied anchors into the drilled holes
3) Route the power/ video cable through the camera mount.
4) Match foot mount holes to the drilled holes
5) Affix the mounting bracket by using supplied screws
6) Adjust the camera direction as below steps.
Direction I
: Adjust the camera direction with
ⓗ
screw for Pan-direction.
Direction II
: Adjust the camera direction with
ⓖ
screw for Tilt-direction.
Direction III
: Adjust the camera direction with
ⓕ
screw for rolling.
