Vitek VT-8243, Manual Instruction

Page: 6 / 40

6
ENGLISH
•
Set the required settings of the air flow using the
switch (3):
« 0 » – the hot air brush is switched off;
« 1 » – low temperature;
« 2 » – high temperature;
« C » – «cool» air supply;
Note: During the first operation some foreign smell and a
small amount of smoke from the heating element is possible,
it is normal.
•
You can move out or remove the thermal brush (7) teeth;
wind a lock of hair around the brush (7), wait a bit and
turn the tip of the thermal brush counterclockwise (the
teeth will be removed into the brush), take the brush (7)
out of the hair.
•
After the hot air brush operation is finished, switch it off
by setting the switch (3) to the «
0 » position and unplug it.
•
Wait till the hot air brush cools down.
•
Remove the attachment by turning it counterclockwise.
Overheating protection
Overheating protection switches the hot air brush off if the
outgoing air is too hot. If the hot air brush is switched off during
operation, set the switch (3) to the «
0 » position, unplug the
unit and make sure that the inlets and outlets are unblocked.
Let the unit cool down for 5-10 minutes and switch it on again.
Do not block the air inlets during unit operation and avoid get-
ting of hair into its air inlet.
CLEANING AND CARE
The нot air brush is intended for household use only.
• Set the switch (3) to the « 0 » position, disconnect the hot
air brush from the mains and let it cool down.
•
To remove the attachment, turn the attachment coun-
terclockwise.
•
Wipe the unit body (2) with a damp cloth and then wipe it dry.
•
Clean the air inlet grid with a brush.
•
Never immerse the unit into water or other liquids.
•
Do not use abrasives and solvents to clean the unit body.
STORAGE
•
Disconnect the unit from the mains and clean it.
•
Never wind the power cord around the hot air brush,
as this can damage the cord or the unit body. Handle
the power cord with care, do not pull, twist or stretch it,
IM VT-8243_70x130.indd 6 16.01.2018 12:38:57