English
8
Temperature indications
Basic block is able receiving data from tree remote sensors, each of them has
each own channel for temperature data transmission. Centigrade or Fahrenheit
degree can be selected as temperature units. Use C/F to select temperature
units.
Switching between data receiving channels
Press button CHANNEL to switch between remote sensors’ data receiving chan-
nels (Ch 1, Ch , Ch ), indoors (IN), switching between different channels’
temperature data indication (
) in cycle.
Temperature trends
Temperature trends are displayed by arrows (increasing, decreasing) near the
adequate data.
Viewing minimal/maximal value of temperature
Each pressing on button MEMORY switches between the next parameters’ indi-
cation:
•
Current temperature
•
Minimal temperature
•
Maximal temperature
Minimal/maximal temperature values reset
Press and hold button MEMORY for seconds to clear all channels’ memories.
Notice:
Remote sensor batteries voltage may decrease while operating at tem-
perature below 0°C, thus remote sensor range of action would be shortened too.
Setting date and current time
Basic block is able viewing current time and date. Press button CLOCK to switch
between current time, date and day of week.
Press and hold button
CLOCK for seconds to set current time and date. You
can choose time indication format (1 hours or hours) and date format (day/
month or month/day), set current time (hours, minutes) and date.
Use buttons
«
▼
/
▲
» to input parameters. Press button
CLOCK for confirmation.
Setting alarm
Press button
ALARM to switch on alarm mode. Symbol «AL» appears on LCD.
Press this button once more to switch alarm ON/OFF, when alarm is on symbol
is on LCD.
6402IM.indd 8
11.04.2008 16:37:16
