English
6
Installation of batteries into remote sensor
1. Turn off the screws on the batteries compartment.
. Select data transfer channel by channels switcher «1--».
. Install batteries (“ААА”, 1.5 V), following polarity.
. Close battery compartment cover and turn up the screws.
Connecting AC-power adapter to basic block/ Installation of batteries into
basic block.
Connect AC-power adapter (,5V;
DC
) to basic block
through the jack for an external power source located below the batteries
compartment.
or
. Open the cover of batteries compartment.
. Install three batteries (“AАА”, 1.5 V), following polarity.
. Close battery compartment cover.
Note:
Basic block is intended for power supply from external source, batteries are
used as reserve power source. Continuous LCD backlight, and continuous pro-
jection of time is possible only in case of connection to external power source
through AC adapter.
Replacing Batteries
On appearance of adequate icon indications displaying that the batteries are
down replace remote sensor batteries.
Get Started
By first startup, switch main block on, and switch on remote sensor. Set data
transfer channel by channel switcher «1--» located on remote sensor. Hold
button CHANNEL on main block, you will hear sound signal. Main block starts
searching remote sensor signal. Press button Тх to reset the sensor. When con-
nection between sensor and main block is set on, temperature indications from
remote sensor will appear on LCD.
Setting pressure parameters by switching on the unit first time
1. After connecting basic block to power supply line pressure units’ icon starts
blinking. Use buttons
«
▼
/
▲
»to select pressure units
, inHg, hPa, mBar or
mmHg.
Press button PRESSURE for confirmation.
. Use buttons
«
▼
/
▲
» to set the value of altitude above sea level. Press
button PRESSURE for confirmation.
Setting pressure parameters via first startup is imperative for precise
weather forecast.
6402IM.indd 6
11.04.2008 16:37:16