Vitek VT-2580, Manual Instruction

Page: 5 / 36

ENGLISH
5
hair clipper operates normally and
the blades move smoothly. If there is
excess oil on the blades, switch the
hair clipper off setting the power switch
(4) to the position «
O » and remove the
excessive oil with a dry cloth.
•
Constantly check the power cord, pre-
vent it from multiple twisting, regularly
switch the unit off and straighten the
power cord.
•
Seat a person so that his/her head is
approximately at your eye level, cover
the person’s shoulders with a towel
and set hair with the comb.
Reminder
–
Always cut off a little amount of hair
at a time; if necessary you can always
return to the cut off part and trim off
additional hair.
–
The best haircutting results are
reached on dry hair, not wet.
–
Comb the hair to reveal uneven locks.
–
It is better to leave longer hair after
cutting for the first time.
–
After learning your clipper better, you
will be able to arrange your hair in any
style you need.
Attachment combs
The length of hair depends on the attach-
ment comb:
–
attachment comb (5): length of hair
left 3 mm
–
attachment comb (6): length of hair
left 6 mm
–
attachment comb (7): length of hair
left 9 mm
–
attachment comb (8): length of hair
left 12 mm
Install the selected attachment comb on
the blades, teeth up, and press on the
ledge in the bottom part of the attachment
until locking. Before cutting hair make sure
that the attachment is locked on its instal-
lation place. To remove the attachment
comb press the clamp and remove the
attachment.
Step one
Set the 3 mm attachment comb (5) or 6
mm attachment comb (6). Switch the unit
on using the power switch (4), setting it to
position «
I ». Hold the hair clipper with the
blades pointed upwards. Start cutting from
the beginning of the hair growth. Slowly
move the trimmer upwards. This way cut
the head back area at neck bottom and
near the ears (pic. 3, 4, 5).
Step two
Switch the hair clipper off with the power
switch (4) by setting it to the position «
O »,
unplug the unit, then set the 9 mm attach-
ment comb (7) for longer hair or 12 mm
attachment comb (8) and continue cutting
hair near top of the head (pic. 6).
Step 3 – cutting in the temples area
Switch the hair clipper off and unplug it,
then set the 3 mm attachment comb (5)
or 6 mm attachment comb (6) and cut hair
in the area of temples. Then set the 9 mm
attachment comb (7) or 12 mm attachment
comb (8) and continue cutting towards the
top of the head (pic. 5).
Step 4 – cutting the crown of the head
Using the 9 mm attachment comb (7) or
12 mm attachment comb (8), cut the hair
on the top of the head towards the crown
against the hair growth direction (pic. 6).
•
You can cut hair against and along
the direction of hair growth, but keep
in mind that the hair cut against the
growth will be shorter than the hair cut
along the growth.
•
Use the 3 mm attachment comb (5)
and 6 mm attachment comb (6) for
very short haircut. To leave a little
longer hair, use the 9 mm attach-
ment comb (7) or 12 mm attachment
comb (8).
•
To leave longer hair, grip hair locks
between your fingers and cut the hair
off using the clipper (pic. 7).
IM VT-2580.indd 5 22.01.2018 16:37:42