MANUAL (T RA NSL A TION)
RAY- LG 35X X
Page 7
RAY-LG 35XX
Version: 1.0
Blanking Routine during Door Opening / Partial Opening Function
The output signal will remain off during the opening of the door until the 11
th
beam is unobstructed (approx.
500 mm opening height). From this position onwards it will be possible to reverse and close the door in
automatic mode. Successively releasing additional light beams will increase this partial opening position
accordingly. During a later closing cycle, the monitored area and the smart blanking function will be limited
to the previously saved partial opening height, higher positioned light beams will remain blanked.
When the power supply of the RAY-LG is interrupted in a partial opening position, it is necessary to open
the door higher than the safeguarded area to allow the system to undergo an automatic initialization
routine.
Installation
WARNING:
Electrical and Mechanical Hazards
Electrical shock and unexpected door movement can cause serious injury or death.
▪
Follow all applicable safety measures
▪
Use only specific and approved tools
▪
If the RAY-LG must be adjusted, the main power supply must be switched off and marked as
“out
of service
”.
Serious Health Risks -
Disregarding these warnings can result in serious injury or death
▪
Never scratch or paint the optical lenses because it
may obstruct the light path! Do not drill additional
holes into the profile. Unpack the profiles just before
installation in order to avoid damage.
▪
Do not bend or twist the edges!
▪
Oil can damage the cables. Contamination must
always be avoided!
▪
Chemical can damage the profile and optical
characteristics. Contact must always be avoided!
NOTICE:
Mechanical Damage to the RAY-LG
▪
Do not drill additional holes into the light curtain
▪
Do not drill through mounting holes
▪
Do not over-tighten the mounting screws
▪
Mount the edges on a flat surface
Risk of damage -
Disregarding this notice can lead to damage to the sensor, the door controller and / or
other devices
