MANUAL (T RA NSL A TION)
RAY- LG 35X X
Page 4
RAY-LG 35XX
Version: 1.0
Delivery Set
RAY-LG comes with a customer-specific delivery package.
A typical delivery package contains:
▪
1 x RAY-LG transmitter bar (Tx)
▪
1 x RAY-LG receiver bar (Rx)
▪
1 x Synchronization cable 10 m (33 ft)
▪
1 x Connection cable 5 m (16.5 ft)
▪
1 x Installation and Operation Manual
Type Key
RAY-LG
A B CD
A: Output
B: Aperture Angle
CD: Number of Optical Elements
A
= 3: Semiconductor/OSE
B
= 5: ±5°
CD
= 20: 20 Elements (2060 mm)
CD
= 22: 22 Elements (2420 mm)
Alignment and Calibration
The optical axis of the emitter (Tx) and the receiver edge (Rx) need to
be aligned towards each other to ensure the light curtain functions
reliably.
Reflective surfaces near to or parallel to the detection area can cause
reflections and interfere with the RAY-LG's functions. Keep a reasonable
distance between the sensor edges and any reflective
surface.
A self-calibration on each optical beam is implemented. At the power- up
the ideal emitting strength will be detected and used. To reduce
interruption caused of dust the system checks the emitting power and
adapt a new higher or lower strength if necessary. After 45 s interruption
a self-reset of the system will be made.
CAUTION:
Damage to the Eye
Although the RAY-LG does not emit dangerous amounts of infrared light, long exposure to intense infrared light
sources can result in damage to the eyes.
- Never look directly into the active infrared emitter from a close distance
Possible health risks -
Disregarding these warnings can result in injury
Figure 3:
Typical RAY-LG delivery set
