Vitec Multimedia CellCom 10, Instruction Manual

Page: 70 / 90

C E L L C O M 1 0 W I R E L E S S C O M M U N I C A T I O N S Y S T E M
7 - 6
CEL-SP REAR PANEL
Serial Data Connector
This 3.5 mm (1/8 inch) tip-ring-sleeve (TRS) connector is used for upgrading
the firmware in the CEL-SP. It will typically be unused.
Power Indicator
This green LED indicates that the splitter is receiving power from the external
power supply.
DC IN Power Connector
This connector is used to locally power the antenna splitter with the supplied
universal power supply. Use of local power is required.
EXP IN Connector
This male DB-15 connector is reserved for future use.
EXP OUT Connector
This female DB-15 connector is reserved for future use.
CONNECTING AN ANTENNA SPLITTER TO THE CELLCOM 10 BASE AND
TO TRANSCEIVER/ANTENNAS
After the connections have been made between the splitter and the
transceiver/antennas, make sure that the data LED’s are lit at the individual ports
on the antenna splitter. Also make sure that the both the green power LED and
the yellow data LED are lit on each CEL-TA transceiver/antenna. If all are
properly lit, then the connection has been successfully made and the coverage
zones will be active and will support beltpacks. If the transceiver antennas are not
lit, check the connections.
1 2 3 4 5
1 Serial Da t a Connec t or
2 Power Indica t or Ligh t
3 DC IN Power Connec t or
4 Reserved for fu t ure use
5 Reserved for fu t ure use
1
2
3
4
5