Vitec Multimedia CellCom 10, Instruction Manual

Page: 58 / 90

C E L L C O M 1 0 W I R E L E S S C O M M U N I C A T I O N S Y S T E M
6 - 8
• Page two shows the next set of assignments for the Talk A and Talk B
buttons (2 assignments).
• Page three shows the next set of assignments for the Talk A and Talk B
knobs (2 assignments).
Figure 6 shows how the front-panel screen on a beltpack displays its six
communications routes.
Figure 6: How the beltpack displays its six communication routes
To activate a talk or listen to an assigned source or destination (“label”):
1. Use the beltpack’s scroll buttons to scroll to the page on which the desired
assignment (“label”) appears. The beltpack holds three pages of assignments.
Each page displays two assignments.
As you scroll, you will hear “beeps” in the headset that correspond to the page
displaying on the beltpack: 1 beep for page 1, 2 beeps for page 2, etc.
2. When you reach the appropriate page, select one or both of the assignments
on that page by depressing the corresponding talk buttons on the beltpack (A
or B).
3. Press and hold the appropriate talk button to talk or listen to the destination.
Release the button to close the talk or listen path.
Alternatively, you can quickly tap the talk button to latch it “on.” Quickly tap
it again to release the latch.
4. To activate another communication route, repeat steps 1 through 3.
You can keep all six communication routes “open” at the same time. You will hear
all activity on these routes in your headset.
Note : Two-wire and four-wire devices can have dual talk-and-listen or just listen
assignments.
Talk A Assi gnm e n ts
Pa g e 1 - Assi gnm e n t 1
Pa g e 2 - Assi gnm e n t 1
Pa g e 3 - Assi gnm e n t 1
Talk B Assi gnm e n ts
Pa g e 1 - Assi gnm e n t 2
Pa g e 2 - Assi gnm e n t 2
Pa g e 3 - Assi gnm e n t 2
Shows c u rre n t pa g e num ber
BELTPACK FRONT-PANEL DISPLAY SCREEN
Note: Use the beltpack ’ s scroll b u tto n s to select a pa g e. O n e pa g e
displays at a ti m e o n the f ro n t-pa n el display.