Vitals BKZ 5022o, Manual

Page: 24 / 92

After each use, chain saws
Service bus and driven sprocket
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
make an external inspection of malfunctions and damage, sagging fuel
and oil detection - eliminate the causes of malfunctions;
Check and tighten all fasteners products;
remove the body chainsaw cylinder cooling fins of the engine, tires and
chains dust, dirt, oil and sawdust;
Clean the ventilation holes;
Check the edges of the tire for wear. If there are burrs, remove them using a
needle file;
Clean and lubricate oil intended for the lubrication of the chain, the driving
and driven sprockets;
Check the cleanliness of the air filter and if necessary, clean it;
Clean the oil supply passage, oil hole.
In case of excessive pollution chainsaw parts and components, for
example - resin, wipe with a special cleaning solution. Bar and chain service
the basis and to place them for 15 minutes in a container of cleaning solution.
After that the bar and chain with clean water and treat with anti-corrosion
spray.
To ensure more even wear on the top and bottom of the tire, turns it over
25 hours every product.
The greatest influence on the durability and performance tires, chain and
sprocket chain saws have three factors - the correct and timely sharpened
teeth chain, the chain tension is correct and orderly function of the mechanism
of chain lubrication.
1. Remove dust and dirt from the gutter tires, oil holes and driven sprocket
(see Figure 22).
2. Make sure that the oil holes are clean.
3. Lubricate the tire groove, driven sprocket, and oil hole oil intended for the
lubrication of the chain.
1. Remove dust and dirt from the drive sprocket.
2. Check the drive sprocket for wear, dents and cracks.
3. If damage or excessive wear of sprocket teeth, replace the drive sprocket.
An indication of the need to change the chain or teeth grinding circuit is the
appearance of small chips. In addition, work dull chain leads to excessive
pressure on the tool operator and can lead to jamming of a timber chain that
dramatically increases the probability of breakage of the drive sprocket and
leads to abnormal overheating blade.
Proper chain sharpening teeth can only be done with the help of special
tools and templates that correspond to this type of chain and must be
purchased separately. For the steps to sharpen the teeth in the user Grinding
to a template or in the literature.
In operation, the wear and the chain is stretched, which in turn leads to
deterioration of the relevant driving and driven Stars. Installation of a new
chain to the worn sprocket causes the mismatch that step is rapid and
intensive wear of the chain and sprockets. Experience shows that it is
appropriate to have a 3-4 chain and sequentially (for example - in a day or two)
to change them to regular wear occurred throughout saw sets of chains, tires
and sprockets.
Service sprocket
Service Chain
2
1
4
3
WARNING!
Do not put a new chain on a damaged, worn sprocket, or a
worn chain on a new sprocket.
figure 22
47 4 6