Vitals BKZ 5022o, Manual

Page: 17 / 92

Starting and stopping the engine
Starting the engine at temperatures above +5 °C
1. Fill the fuel tank fuel mixture.
2. Fill the oil tank oil used to lubricate the chain.
3. Turn the chain brake.
4. Place the ignition switch (1) to the upper position "I" (see Figure 11).
Make sure the tire is not touching any other object.
6 Place the chain saw on a flat surface. Hold a product as shown in Figure 11.
5.
.
7. Pump the fuel to the carburetor, using the manual fuel pump "primer". To do
this, click on the cap 4-6 times "primer" (22) until it appears fuel (see Figure
1).
8. Pull the handle all the way Choke (2) in the direction of arrow (A) (see
Figure 11). In this case, close the choke valve.
9. Operate the starter motor: first gently pull the starter handle (3) (see Figure
11) in the direction of the arrow (B) until you feel resistance. Sensing
resistance, return the handle to the original position, and then abruptly pull
the starter handle. Repeat this process 2-3 times until the engine starts to
"catch." Once the engine will "catch", stop the process of starting the
engine chainsaw and immediately open the choke by turning the valve to
its original position.
10.Again, pull the starter grip to start the engine. Once the engine is running
chainsaw, starter handle slowly return to starting position.
11. Warm up the engine for 1-3 minutes (depending on ambient temperature)
until the engine begins to work on the stable idle.
12.Unlock the chain brake.
CAUTION!
To avoid injury to start the engine chainsaw is only necessary
when the brake circuit.
WARNING!
To prevent failure of the clutch centrifugal clutch and chain
brake mechanism does not allow the engine revving
chainsaw while the brake circuit.
WARNING!
When you press the throttle lever choke valve opens
automatically (only for BKZ 5823os).
WARNING!
Pull the starter handle to be very careful not to pull the starter
cord. figure 1 1
3 3 32
B