Vitals BKZ 5022o, Manual

Page: 20 / 92

1. Make the first cut down to 2/3 the diameter of the trunk of a tree (see
Figure 14).
2. Turn the log and cut (2) it from the opposite side (see Figure 15).
1. Make cuts logs in the "A". Make the first cut from the bottom up (1) 1/3 of the
log and finish the cut from the top down.
2. If the timber has two points of support at the edges of the support and are
positioned correctly in relation to the center of gravity, the first cut (area 'B')
to make downward (a third the diameter of the log), and the second propyl -
upward (toward the first).
Sawing logs with underplayed supports (see Figure 16)
If, however, a tire jammed and can not pull out without applying significant
effort, in any case, do not pull a chainsaw and do not try to pull out. Stop the
operation of the product, drive pin in the cut to reveal it, and then gently pull out
the bus.
When cutting logs are best used as a stop goats. Make sure when cutting
logs securely in place (see Figure 17).
Make the first cut from the bottom up to 1/3 of the log and finish the cut from
the top down. Gently slide the timber and repeat cutting.
Sawing logs using goat
Pruning branches and twigs
2-nd notch
Upheaval
180°
Upheaval
180°
NOTE!
If you make a cut on the wrong side, there will be a pinched
tires in the wood.
CAUTION!
During sawing not keep a chainsaw at arm's length, and
placed vertically or overhead (see Figure 18).
Be careful that you do not toe the tire touched a tree trunk and
branches nearby.
figure 5 1
figure 6 1
figure 7 1
3 9 3 8
1st saw-cut
2nd saw-cut
1 : st saw-cut
bottom to top
2 : nd saw-cut
top to bottom
1/3
tree
trunk
diameter
1st saw-cut
2nd saw-cut
2 : nd saw-cut
bottom to top
1 : st saw-cut
top to bottom
А
В
1/3
tree
trunk
diameter