10
1. The modular system
2. First use
3. Scope of supply/system solutions
2.2 Set up sintering unit
•
Please ensure that the following conditions are met.
Please note:
•
Set the device up in a dry, heated room. The distance between the sintering unit and the next wall should be at least 50 cm.
•
When the temperature is below 15°C (e.g., after transport), leave the device to stand for approx. 60 minutes at room
temperature before using it for the first time.
•
Ensure that the unit is installed on a heat-resistant and non-flammable surface.
•
The radiation and heating of the device is within a non-hazardous range. Nevertheless, heat sensitive surfaces of furniture
and veneers may become somewhat discolored over time, due to the constant influence of heat. Therefore, maintain a
minimum distance of 50 cm.
•
Avoid direct sunlight on the device.
•
Do not place flammable objects near the device.
•
Do not place the control unit directly in the area of heat radiation of the sintering chamber.
•
The distance between the sintering furnace and the control unit must be at least 20 cm.
•
Set up the device in such a way that the main switch can be easily accessed and the power supply cable can be easily
disconnected. Before using the device for the first time, please read the corresponding operating manual for the control unit.
•
An electrical connection to distribution outlets with an extension is not permitted.
2.3 Status display
Blue:
Firing program active
Red
: Error – blinking mode
Blinking
green
/
red
: Update is running
•
When the unit is not in use, move the lift plate upwards and switch off the unit from the main switch.
•
Closing the sintering chamber protects the insulation and prevents moisture absorption.
2.4 Switch off sintering unit and control unit
