OSD Menu Instruction
15
4.2 MOTION DETECTION:
4.2.1
SENSITIVITY (LOW/ NORMAL/ HIGH):
You can select the degree of sensitivity of motion detection.
Set to HIGH for greater sensitivity to small movements.
4.3 SCHEDULE SETUP:
4.2.1
TIME:
4.2.2
TIME & EVENT:
Start to record when schedule recording time is set up.
Record when motion is detected within schedule recording time.
Schedule the recording time on this menu. Up to 4 schedules can be set.
Configure the period of time when recording is available.
5. SUB MENU
5.1 PASSWORD ENABLE (YES/ NO):
To change a password, navigate to PASSWORD CHANGE in the SUB MENU and press
the select button [ENT]. The factory defacult password is 0000. To enter this number, press
the [UP/DOWN] button on the remonte controller. Once you input your current password, set
a new password using the [UP/REW/DOW/FF] on the remote controller. Then, confirm your
new password by entering the number again.
Select NO if you want to disable the password to accessing to the OSD menu.
4. EVENT SETUP
4.1 ALARM SETUP
4.1.1
ALARM INPUT (ON / OFF):
Select “ON” if you want to use alarm input device.
4.1.2
INPUT TYPE:
NO (NORMAL OPEN): In NORMAL-CLOSE mode, if an intruder cuts the cable line that
connects the sensor to the encoder board, the sensor recording
NC (NORMAL CLOSE): In NORMAL-OPEN mode, if an intruder cuts the cable line that
connects the sensor to the encoder board,
Select alarm input type between “NO” and “NC”.
the sensor recording will not start.
starts automatcially.
