Visonic PowerMaster-10 G2 Quick User Manual Download Page 31

Page: 31 / 96

5. PROGRAMMING

D-304762 PowerMaster-10/30 G2 Installer's Guide

- Adding New Devices

[1]

Enter "

INSTALLER MODE

", select "

02:ZONES DEVICES

" (see section 5.2) and then select "

ADD NEW DEVICE

Because of encryption, PowerG devices (including Keyfobs) cannot be used on more than one system at one
time. Remember to verify panel and device compatibility.

[2]

See enrollment by button or device ID below. If enrollment is successful, the display reads "

DEVICE ENROLLED

(or

ID ACCEPTED

and then shows the device details - see [3]. However, if the enrollment fails, the display will

advise you the reason for failure, for example:

ALREADY ENROLLED

" or "

NO FREE LOCATION

If the enrolled device is adapted to operate as another device that the panel recognizes, the display then reads
“

ADAPTED TO <OK>

”.

[3]

The display shows the device details and the first available free Zone number for example: "

Z01:Motion

Sensor

ID No. 120-1254

" (

K01:Keyfob

S01:Siren

etc. depending on the type of the enrolled device).

Both Wireless and wired detectors can be enrolled in any zone number. To change the zone number, click the

button or type in the zone number, and then press

to confirm.

[4]

Continue to Part B to configure the device – see diagram below

How to check Panel

Device compatibility

Each PowerG device bears a

7-character Customer ID printed on the device sticker in the format: FFF-M:DDD, (for

example, 868-0:012) where FFF is the frequency band and M:DDD is the variant code. For PowerG system devices
compatibility, make sure the frequency (FFF) band of all devices are the same and that the variant code of the devices
match the variant code on the panel.

Enrollment by using Device ID

The 7-digit Device ID can be used to register a device into the panel locally or from a remote location using the Remote
Programmer PC software. The enrollment by device ID is a 2 stage procedure.
In the 1

stage you register the devices' ID numbers into the panel and complete the device configuration. This can be

done from a remote location using the Remote Programmer PC software. Following the 1

stage, the PowerMaster

panel waits for the device to appear on the network in order to complete the enrollment.
In the 2

stage, the enrollment is completed when the panel is in full working mode by inserting the battery into the

device, or by pressing the tamper or enrollment button on the device. This procedure is very useful for adding devices
to existing systems without the need to provide technicians with the Installer Code, or to allow access to the
programming menus.

Remember! The system will indicate a "

NOT NETWORKD

" trouble until the 2

stage of all registered devices is

completed

Note:

The Soak Test

on pre-enrolled zones can be activated only when the zone is fully enrolled.

Enrollment by using the Enrollment button

The panel is set to the Enrollment mode (step #2 above) and the device is enrolled using the Enroll button (refer to the
device information in the device Installation Instructions, then open the device and identify the

Enroll button

. For

keyfobs and keypads, use the

AUX

' button. For gas detectors,

insert the battery

Press the enroll button for 2-5 seconds until the LED turns ON and then release the button. The LED will extinguish or
may blink for a few more seconds until the enrollment is completed. If enrollment is successfully completed, the
PowerMaster sounds the "Happy Tune" and the LCD momentarily shows "

DEVICE ENROLLED

" and then reads the

device details.

Enrollment of wired sensors

To enroll a

wired sensor

into the wired zone, enter ID: 050-0001 or 050-0002.

Part B - Configuration

Step 1

Step 2

Step 3

Step 4