1717 W Civic Drive, Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© 2018 Visa Lighting
When using electrical equipment, basic safety precautions should always be followed, including the following:
•Read all instructions carefully before installing and save for future use.
•Make sure all connections are in accordance with the National Electrical Code and local regulations.
•To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
•Service should be performed by qualified personnel.
•These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.
!
Model: CV2424
Linesse Linear Slot
Publication: 762302XX
Document Description: Installation Instructions
for 3” Linesse Linear Recessed
Series Luminaires
9
CORNER INSTALLATION INSTRUCTIONS FOR MOUNTING
IN HARD CEILING AND JOINING FIXTURES
1. Prepare wall/ceiling with rough-in openings
(see chart on page 3.
2. For post sheetrock applications use holes on back
of fixture to tie into the building (supplied by others).
Remove lens.
3. Install building power feed (supplied by others)
thru top side of housing or thru end cap. Attach
power to harness using the starter harness and plug
into the fixture thru harness. Use the wiring diagram
included to identify wiring.
4. Insert fixture thru rough-in opening and fasten
fixture (hardware supplied by others) to building studs.
•
Center fixture in opening
•
Predrill holes for screws and countersink 3/16”
for “Trimless/Flangeless” fixture
Vertical IN Corner
Vertical OUT Corner
Trimless
Rough-In
Width
3-11/16”
Flange
Rough-In
Width
3-11/16”
Building Power Feed
All Thread (supplied by others)
Post sheetrock applications
Slider Channel
Predrill mounting holes
in slider channel
Do not over tighten
Flange
Predrill and countersink
mounting holes
(if needed)
Trimless/Flangeless
