1717 W Civic Drive, Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© 2018 Visa Lighting
When using electrical equipment, basic safety precautions should always be followed, including the following:
•Read all instructions carefully before installing and save for future use.
•Make sure all connections are in accordance with the National Electrical Code and local regulations.
•To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
•Service should be performed by qualified personnel.
•These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.
!
Model: CV2424
Linesse Linear Slot
Publication: 762302XX
Document Description: Installation Instructions
for 3” Linesse Linear Recessed
Series Luminaires
8
CORNER INSTALLATION INSTRUCTIONS FOR MOUNTING
IN T-GRID AND JOINING FIXTURES
1. Remove lens and install hanger brackets.
For 9/16” lay-in grid, place smaller gap side
of bracket towards lens. For other grids,
place wider gap side towards lens.
2. Set fixture into opening between T-Grid.
Screw in #8 self threading screws in hanger
bracket and attach support wiring to the
building and fixtures.
3. Bring conduit and conduit filling (supplied
by others) to the power feed hole location
at the end of the housing. Make the electrical
connections to the building power. Use the
wiring diagram included to identify wiring.
4. For row mounting attach harnesses.
5. Center lens sections.
6. Slide fixture together using sliders.
7. Screw internal reflectors down to joining fixture.
8. Tuck harness at end of rows and attach end caps
using supplied screws. Replace lens.
9. Grid end caps can be adjusted for lay in or slot T
configurations (use extra holes to adjust).
Note:
Horizontal grid corners has endcaps and
a starter harness provided. Please discard the
component not needed for your project. If the
harness needs reversed for a left, use the 4”
adapter harnesses provide in the hardware kit.
Use Chart on Page 3 to determine
Grid mounting widths.
Approximately 4”
Hanger Brackets
Support Wire
Mounting Screws
Through Harness
Lens
Sliders
Smaller Gap Side of Bracket
for 9/16” Lay-in Grid
Building Power Feed
Starter Harness
Through Harness
Inside View
Fasten extended reflector tabs
to joining fixture.
Carefully break tab at end of run
Fasten end cap to end of run
