ENGLISH
EN
12
TRAINING WITH HEART RATE
Hand
sensors
This VirtuFit fitness machine is equipped with hand sensors to
measure heart rate. The hand sensors are attached to the handle
and only work if both sensors are held for a long time. For optimal
performance, it is important that the hands are slightly damp and exert
constant pressure on the sensors. Hands that are too dry or too wet
may result in abnormal readings.
MAINTENANCE
Safe and efficient use can only be achieved if the appliance is
properly installed and maintained. It is your responsibility to ensure
that the appliance is maintained regularly. Parts that have been
used and/or damaged must be replaced before the appliance is
used again. The appliance should only be used and stored indoors.
Long-term exposure to weather and temperature/humidity changes
can have a serious impact on the electrical components and moving
parts of the unit. Always unplug the power cord from the unit before
cleaning or servicing it.
Daily maintenance
• Clean and remove sweat and moisture after each use.
• Check that the unit is free of dust and dirt.
• Do not use aggressive cleaning agents and keep the device
away from moisture.
Semi-annual maintenance
• Inspect all bolts and nuts connected to the moving parts of the
unit. Tighten bolts and nuts as necessary and appropriate.
• Check the mobility of moving parts and components of the unit.
Use silicone spray if necessary and appropriate.
We recommend the following:
• Clean the unit after use.
• Use a dry cloth to clean the control panel and the areas around
the on/off switch.
• Use a soft, clean cloth and detergent to remove stubborn marks
and dirt from the unit.
• Store the unit in a safe, dry place away from heat and water.
CAUTION!
•
Repairs must be carried out by a professional technician,
Hex head bolts:
Make sure that the hex head spanner is pushed into
the bolt before applying force. This will prevent the head of the socket
bolt from turning.
ADJUSTING
Adjusting the saddle (A)
In order to train effectively, it is advisable to adjust the saddle to the
correct height. When pedalling, your knees should be slightly bent
when the pedals are in the down position.
To adjust the saddle to the vertical position, follow the steps below:
• Loosen the knob on the seat post and pull the knob towards you.
• Move the seat post up or down until the saddle is in the desired
position and release the knob.
• Move the seat post slightly up or down to ensure that the knob
is in one of the adjustment holes.
• Tighten the knob on the seat post.
Volg onderstaande stappen om de horizontale positie van het zadel
te verstellen:
• Loosen the saddle knob a few turns.
• Slide the saddle forward or backward until it is in the desired
position.
• Tighten the saddle knob.
Adjusting the handlebars (B)
To adjust the handlebar angle, follow the steps below:
• Loosen the knob.
• Tilt the handles to the desired position.
• Tighten the knob to secure the handles.
Adjusting the foot straps (C)
To adjust the foot straps, follow the steps below:
• Remove the end of the foot strap from the lips of the pedal.
• Adjust the footrest to the desired position.
• Attach the end of the foot strap to the tabs on the pedal.
A
B
C
