4: Configuring WebWayOne 2424 Communicator
Installing and Configuring the GW8600 SMG
© Virtual Access Ltd.
Issue 1.1
Page 9 of 12
4
Configuring WebWayOne 2424 Communicator
4.1
Equipment and information that you need before you start
4.1.1
Equipment requirements
To configure WebWayOne 2424 Communicator, you need:
•
a laptop or PC with HyperTerminal, and
•
a console cable.
4.1.2
Information requirements
If the network at the alarm site uses DHCP, go to section 4.2.
If the network at the alarm site uses static IP addressing, get the information in Table 2
before you configure the WWO 2424B Communicator.
Parameter Name
Value for this installation (fill in the field)
IP address
Subnet mask
Default gateway IP address
Table 2: Configuration parameters for the WebWayOne 2424B Communicator
4.2
Attaching the GW8600 SMG to a console
1.
Connect the 3-way Molex connector of the console cable to connector J6 on
the WebWayOne 2424B Communicator. Figure 5 shows the Molex connector.
Figure 5: The 3-way Molex connector
2.
Connect the other end of the console cable to a serial port on a PC or laptop.
