Connections
Figure 4
Backlighting can be trough USB or external 5V DC
power supply. The jumper in the red box in figure 4 is
by default on internal power over USB. For external
power replace the jumper on the middle and bottom
pin.
The pins in the green box is where you connect the
external 5v DC power supply , left pin is the 5v + right
pin is for GND.
By default the PCB is fitted with a small 4 way
navigation switch to act as the DCS, but can be rap
laced by a real DCS switch. De Solder the small switch.
Drill the centre hole bigger using a drill to the size
Summary of Contents for ICP V1.7
Page 12: ......
