Vipergear ICP V1.7, Operation

Page: 4 / 12

SimWarnReset 22 -2 -2 0 0x0 0
SimDriftCOOff 22 -2 -2 0x42 0x0 0 "ICP: DRIFT C/O Switch -
NORM"
SimDriftCOOn 24 -2 -2 0 0x0 0 "ICP: DRIFT C/O Switch - ON"
SimDriftCOOff 24 -2 -2 0x42 0x0 0 "ICP: DRIFT C/O Switch -
NORM"
SimArmMasterArm 23 -2 -2 0 0x0 0 "MISC: MASTER ARM Switch -
ON"
SimSafeMasterArm 23 -2 -2 0x42 0x0 0 "MISC: MASTER ARM Switch
- OFF"
SimSafeMasterArm 25 -2 -2 0x42 0x0 0 "MISC: MASTER ARM Switch
- OFF"
SimSimMasterArm 25 -2 -2 0 0x0 0 "MISC: MASTER ARM Switch -
SIM"
So if you have read the chapter 6.1 of the key file
manual you understand the lines above.
Note(I made this example in the BMS FULL Key file but
this has to be done in the key file you use. Before you
continue it would be wise to make a backup of your key
file)
Go to BMS setup page and select the controller tab
screen. Scroll down to the ICP section and highlight the
DRIFT/CO function. Once it’s highlighted put the
according toggle switch into the Drift/CO position. On
the button a number will appear, note this number
down on a piece of paper. In this example its 89 but
yours can be different. Push the toggle back in its
centre position.(see figure.1)