© 2005 Directed Electronics—all rights reserved
5
51
1
and rearmed, and still allow NPC to bypass a faulty zone.
When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been
bypassed. (See
Diagnostics section of this guide.)
vvaalleett m
mooddee
TTo
o een
ntteerr o
orr eexxiitt vvaalleett m
mo
od
dee w
wiitth
h tth
hee vvaalleett//p
prro
og
grraam
m ssw
wiittcch
h::
1.
Turn the ignition key on and then off.
2.
At anytime during the next 10 seconds, press and release the Valet switch. Now the Status
LED will light constantly if you have entered Valet Mode, and go out if you have exited
Valet Mode.
TTo
o een
ntteerr o
orr eexxiitt vvaalleett m
mo
od
dee w
wiitth
h tth
hee ttrraan
nssm
miitttteerr::
To enter or exit Valet Mode with a transmitter:
1. Open any door.
2. Press
on the transmitter.
3. Press .
4. Press
again. You have now entered or exited Valet Mode (verify by checking your status LED).
ttiim
meerr m
mooddee
This unit can be programmed to start and run the engine every three hours, for a maximum of six cycles. The
engine will run for the programmed run time and then shut down. After three hours, the system will restart the engine.
IIM
MP
PO
OR
RTTA
AN
NTT!! Timer Mode should be used only in open areas. Never start and run the vehicle in
an enclosed space such as a garage or carport.
TTo
o een
ntteerr o
orr eexxiitt ttiim
meerr m
mo
od
dee w
wiitth
h tth
hee ttrraan
nssm
miitttteerr::
The same procedure may be used to enter or exit Timer Mode using the remote transmitter:
1. Remote start the vehicle by pressing
and
simultaneously.
