3
Deployment Panel PC
3.1 Installation
The Panel PC is suitable for the installation in operating tables and
control cabinet fronts. The installation happens via the backside. The
Panel PC is provided with a fixing technique with not losable screws
that allows an easy connection with a crosstip screwdriver. A fast and
easy device change is possible. It is also possible to install the Panel
PC in a VESA holder (100mm x 100mm).
For the installation into a operating tableau and control cabinet fronts,
the Panel PC requires the following front panel cutting:
Panel PC
W x H in mm
67S-PNL0-...
547 x 367mm
The material thickness of the installation cut-out is 3 ...
12mm.
For the installation of the panel pivoted lever are integrated. For the
installation, a small slit screwdriver is required.
1.
Push the Panel PC [3] from the front side into the front panel
cutting [1] until it touches the panel with the seal [2].
2.
Rotate the pivoted lever 90 degrees to the outside [4].
3.
Screw the screws with the crosstip screwdriver [5].
Overview
Installation cutting
Installation
VIPA HMI Panel PC
Deployment Panel PC
Installation
HB160 | PPC | 67S-PNL0 | GB | 14-24
24
