Solar Surveillance Installation Manual - Version: VIPSLRB-Q121
14
2.8 Reconnect Battery
The Solar Light is shipped with the battery disconnected from the system.
To activate the Solar Light, this battery must first be reconnected. To reconnect:
1. Remove the “Battery Disconnected” sticker.
(Fig 2.8a)
2. Find the two cables labeled “Battery”.
(Fig 2.8b)
3. Taking note of the cable key, connect the two cables.
(Fig 2.8c)
4. Twist the waterproof locking connector until tight.
(Fig 2.8d)
5. Install the solar panel connection cover, included in the solar panel accessory bag.
(Fig 2.8e)
Fig. 2.8a
Fig. 2.8b
Fig. 2.8c
Fig. 2.8d
Fig. 2.8e
Once the battery is connected, a red LED will flash slowly inside the black sensor on the solar panel. If the battery is
connected correctly and this does not occur, this likely indicates low battery voltage - place the system in direct sunlight
for at least 1 hour to charge before continuing.
