Back
29
Drag control knob adjustment
When turned fully clockwise, the ‘V’ notch on the drag control knob should be within the limits
shown. To adjust the drag control knob:
Turn the drag control knob fully clockwise.
Remove the hole plug
(6.1)
. Remove the screw
(6.2)
and washer
(6.3)
securing knob
(6)
to
the spindle
(6.4)
.
Remove the knob, then replace on spindle
(6.4)
so that the ‘V’ notch on the knob is within
the limits shown.
Degrease screw
(6.2)
, coat with Loctite 222E and secure knob with washer
(6.3)
and screw
(6.2)
. Replace hole plug
(6.1)
.
Skid clamp adjustment
To adjust the skid clamp
(16)
:
The skid clamp is applied or released by turning the handle clockwise or counter-clockwise.
The handle has a pull-off/push-on ratchet adjustment. To take up wear, pull the handle
away from the spindle, rotate counter-clockwise and release.
Repeat the above procedure, as necessary, until the clamp locks when applied but allows
free movement when released.
Fig 6 Drag knob adjustment
(6.4)
(6.1)
(6.2)
(6.3)
(6)
30°